MOD. FF6
FEATURES
- The device receives an end of material feed signal externally
- It can be used when other interlocking peripheral devices are required
- The output is enabled or disabled by the operation switch, and the external input
MOD. DS6
FEATURES
- Direction change device
- It is possible to reverse the roller's direction of rotation via the change-over switch
- Allows material to be fed in both tension and thrust
- Models R20, R30, R40, R50 and J25 are equipped with a one-way brake. When the engine is switched off, the rollers remain in the grip. For direction change options, the brake is released to allow reversing.
MOD. BS6
FEATURES
- The device receives a material feed signal externally.
- It can be used when other interlocking peripheral devices are required
- FF6 and BS6 can be used synchronously
MOD. MP6
FEATURES
- Multi-step device/database
- 99 different feed steps, feed angles and release modes can be stored
- It is possible to recall the preset recipe/series of mould commands without re-entering the feed conditions when the mould is changed.
- Up to 99 different command settings can be programmed. This way, this unit can perform multiple operations as a single unit of multiple operations.
- The number of operations on a single stage is up to 99.
- By combining MP6 and DS6, it is also possible to programme the change of supply direction.
MOD. RC6
FEATURES
- Wired remote control reproducing main controls
- Facilitates remote operation and belt adjustment within the mould
- Cable length can be selected as 3m or 5m
- The feed speed in ONE STROKE mode can be modulated as required
- For safety, the main controller is switched off when using RC6A. During synchronisation with the press, the RC6A commands are deactivated.
Special rollers
FEATURES
- Rollers made of a special material: Urethane, BBC, Silicone and Separated (not for G/TG series)
WORK SENSOR
FEATURES
- A device that stops the feeder and press at the end of the reel's useful tape
- It is an optical sensor that detects the material outside.
- The sensitivity of the optical sensor can be adjusted according to the environment.
- It can be installed in all series
- The mounting method and position vary depending on the model.
APRON ROLL
FEATURES
- An extension roller can be added to the infeed side for optimal material, guiding the feeder to stabilise the roll material.